Platí pro: Rear axle 746.27/97 in model 382.171/177/180/181/185/188/189 Rear axle 746.960 Rear axle 746.961/964 in model 693.184/191/195, 695.043 Rear axle 746.962 in model 386.014 Rear axle 746.964 in model 693.144 Rear axle 746.966 in model 693.128, 695.014 Rear axle 746.974 in model 634.081 Rear axle 772 in model 695.302
Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.
Platí také pro motory/převodovky: 746 27*, 746 960, 746 961, 746 962, 746 964, 746 966, 746 97*, 746 974, 772 ***
AR35.30-B-4302-01A
Adjust preload of tapered roller bearings
Rear axle
746.27/97 in model 382.171/177/180/181/185/188/189
Rear axle
746.960
Rear axle
746.961/964 in model 693.184/191/195, 695.043
Rear axle
746.962 in model 386.014
Rear axle
746.964 in model 693.144
Rear axle
746.966 in model 693.128, 695.014
Rear axle
746.974 in model 634.081
Rear axle
772 in model 695.302
055 589 05 21 00
Adjusting device
1
Gradually tighten the ring (1) just enough to clear the gap between the sprocket and pinion teeth. Then loosen it from 3 to 4 castles.
Make sure that one of the ring holes (1) is aligned with the locking pin of the locking plate.
B35.30-0051-01
2
Gradually tighten the ring (2) using the pin wrench (3) until the clearance of the bearings is eliminated. From this point tighten it more, to get the necessary preload. For NEW bearings = tighten from 2 to 3 castles. For USED bearings = tighten from 1 to 2 castles.
