Hub
Number | Designation | Rear axle 745.990 with ring gear | Rear axle 745.996 with | |||
BA35.20-N-1002-06E | Inner slotted nut, wheel hub to axle tube | Stage 1 | Nm | 300 | 550 | |
2nd stage Slacken | ° | -45 | -45 | |||
BA35.20-N-1003-06E | Outer slotted nut, wheel hub to axle tube | Nm | 400 | 550 | ||
Hub
Number | Designation | Rear axle 745.997 with ring gear | |||
BA35.20-N-1002-06E | Inner slotted nut, wheel hub to axle tube | Stage 1 | Nm | 300 | |
2nd stage Slacken | ° | -45 | |||
BA35.20-N-1003-06E | Outer slotted nut, wheel hub to axle tube | Nm | 400 | ||
000 589 39 21 00
Torque wrench
Claw-type wrench
385 589 04 07 00
T35.20-0017-01
1 Release locking plate on outer slotted nut (4) and unscrew.
2 Remove locking plate (5).
3 Tighten inner slotted nut (1) while rotating the rear wheel hub (2) and lightly hammering the rear wheel hub (2) (with plastic or rubber hammer).
4 Slacken inner slotted nut (1) again.
5 Tighten inner slotted nut (1) until it lies on the pressure washer (3).
There must be neither play nor tension between the inner slotted nut (1) and the pressure washer (3).
6 Slacken the inner slotted nut (1) by the angle specified above.
7 Install locking plate (5).
8 Tighten outer slotted nut (4)
9 Release tension in rear wheel hub tapered roller bearing by hammering lightly (plastic or rubber hammer).