Remove/install track rod and replacement of rubber mount

AR35.20-P-0112V

Remove/install track rod and replacement of rubber mount

28.6.07

 

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A



Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

1

Raise vehicle with lifting platform

AR00.60-P-1000V

2

Remove wheel.



Remove/install wheels, rotate if necessary

AP40.10-P-4050V

3

Detach tie rod (4) from wheel carrier

 Do not damage the tie rod rubber boot.

 Installation: Clean grease off the ball head bolt as well as beveled seat in the wheel carrier. Press ball head bolt firmly into the cone and if necessary hold securely using an Allen wrench.



*BA35.20-P-1002-04A

 Puller

*201589013300

 Thrust piece, M 101.5

*210589046300

4

Mark eccentric disk of tie rod (4) relative to the rear axle carrier (arrow)

5

Detach tie rod (4) from rear axle carrier



*BA35.20-P-1001-04A

6

Check rubber mount (4b) for damage, replace rubber mount (4b) if necessary

AR35.20-P-0112-01P

 Extraction and insertion tool

*203589014300

7

Install in the reverse order

8

Perform a wheel alignment check

AR40.20-P-0200V

Number

Designation

Model 171

BA35.20-P-1001-04A

Self-locking nut, track rod to rear axle carrier

Stage 1

Nm

70

Stage 2

°

-

BA35.20-P-1002-04A

Self-locking nut, tie rod at wheel carrier

yellow M101

Nm

30

silver or blue M101

Nm

25

silver or blue M101.5

Stage 1

Nm

20

Stage 2

°

45