B35.10-0013-09
1 | Propeller shaft | 5 | Parking brake pneumatic piping | |
2 | ALB drive cable fastening screw | 6 | Service brake pneumatic piping | |
3 | Pneumatic lines connections | 7 | Pads wearing sensor | |
4 | Breather line | 8 | Screws |
9 | Screw |
10 | Shock absorber |
11 | Upper guide plate |
12 | Spring U-bolt |
B35.10-0014-06
| Remove/install | ||
1 | Remove rear wheels. | ||
2 | Drain the oil from the rear axle housing. | ||
| Rear axle - oil change | ||
3 | Release the clamp and remove the breather hose (4) on the axle side. | ||
4 | Depressurize the pneumatic system at the reservoirs. | ||
5 | Disconnect the pads wear sensor end piece (7). | Installation: Replace the screw. | |
6 | Loosen the pneumatic line connections (3) from the combined cylinders. | Installation: Install new sealing washers. | |
7 | Remove the pneumatic lines from the service brake (6) and hand brake (5) in the combined cylinders. | ||
8 | Unscrew the screw (2) and loosen the drive cable from the brake force control valve. | ||
9 | Unscrew the shock absorber lower eye nuts (9). | Installation: Check rubber bushing conditions of the shock absorbers and torsion bar. | |
Installation: Assemble new self-locking nuts. | |||
Dumpers on the rear axle | |||
10 | Loosen the coupling fork on the rear axle side and secure the propeller shaft (1) to the chassis. | Pre-mark the original position between the propeller shaft and shaft coupling forks to maintain balance. | |
Propeller shaft attachment | |||
11 | Insert an appropriate lifting device under the rear axle and lift it slightly. | | |
12 | Loosen the nuts and remove the spring U-bolts (12), the upper guide plates (11). | Installation: Go through and lubricate the threads of the “U” bolts. | |
Rear spring clip | |||
13 | Remove the stabilizer to rear axle screw (9). | .Torsion bar in the rear axle carrier | |
14 | Lower the axle and remove it. | ||
15 | Install in reverse order. | ||
Check | |||
16 | Check and adjust load-sensitive brake (ALB). |