Replace mount of lower transverse control arm

AR33.20-P-0527RT

Replace mount of lower transverse control arm

2.2.07

 

Remove/install



Notes on self-locking nuts and bolts

All models

AH00.00-N-0001-01A



When working on the front-end assembly, be careful not to scratch, mark or notch the surfaces of aluminum parts. Otherwise the service life of the parts will be affected

1

Remove front wheel



Remove/install wheels, rotate if necessary

AP40.10-P-4050RT

2.1

Detach lower engine compartment paneling

Model 251 with gasoline engine

AR61.20-P-1105RT

2.2

Remove noise encapsulation

Model 251 with diesel engine

AR94.30-P-5300RT

3

Support lower transverse control arm (3) using transmission jack

4

Loosen heat shield of rear mount (1)

Right-hand side only

5

Loosen bolt (2)



*BA33.20-P-1008-01L

6

Detach bolted connection (4)



*BA33.20-P-1009-01L

7

Detach bolted connection (5)



*BA33.20-P-1005-01L

8

Unscrew rear mount (1)

 Remove rear mount (1) with bolt (2).

 Installation: Pay attention to correct position of pinned connection (arrows).

9

Install in the reverse order

10

Perform a wheel alignment check

AR40.20-P-0200RT

Number

Designation

Model 251

BA33.20-P-1005-01L

Bolt, lower transverse control arm at inside rear to front axle carrier

Nm

250

BA33.20-P-1008-01L

Bolt, rear bearing to lower transverse control arm

Stage 1

Nm

100

Stage 2

°

90

BA33.20-P-1009-01L

Outer rear nut of lower transverse control arm to front axle carrier

Nm

150