ar3320p0425i

Checking supporting joint and follower joint of steering knuckle mount (removed)

Typ ar · téma 33.20 · verze 0117 · 2005-11-08

Platí pro: MODEL 211, 215, 220, 230

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 2 Podvozek › 33 Přední náprava › 33.20 Vedení kola, náboj — Řada 211 · Řada 215 · Řada 220 · Řada 230

EinPAS 17 Hnací ústrojí/náprava › 17.50 Přední náprava › 17.50.42 Čep nápravy/náboj kola/ložisko kola — Řada 211 · Řada 215 · Řada 220 · Řada 230

AR33.20-P-0425I

Checking supporting joint and follower joint of steering knuckle mount (removed)

26.10.05

MODEL 211, 215, 220, 230

Checking supporting joint and follower joint of steering knuckle mount (removed)
Checking supporting joint and follower joint of steering knuckle mount (removed)

P33.20-2021-01

Shown on model 220

7f Supporting joint rubber boot

8f Follower joint rubber boot

P33.20-2009-01

Checking

1

Move the ball pin in all directions with an approximately 150 mm long pipe

The ball pin should move without play (without seizing), and should not cause any creaking noise.

2

Check rubber boot (7f) on supporting joint for cracks and damage

Replace supporting joint if necessary.

3

Check rubber boot (8f) on follower joint for cracks and damage

If necessary, replace follower joint or upper transverse control arm.

For upper transverse control arms made of die-cast aluminum the upper transverse control arms must be replaced.

For upper transverse control arms made of sheet metal aluminum the follower joint must be replaced.

AR33.20-P-0427TX

Odkazované dokumenty