ar3320d145203a

Attach transverse control arm to steering knuckle and front axle beam

Typ ar · téma 33.20 · verze 0112 · 2009-11-17

Platí pro: FRONT AXLE 730.408 /410 in MODEL 901, 902 FRONT AXLE 730.409 in MODEL 902 FRONT AXLE 730.409 /413 in MODEL 903 FRONT AXLE 730.411 /414 in MODEL 904 FRONT AXLE 732.2 in MODEL 690.6

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 2 Podvozek › 33 Přední náprava › 33.20 Vedení kola, náboj — Řada 690 (modely 6**) · Řada 901 · Řada 902 · Řada 903 · Řada 904

EinPAS 17 Hnací ústrojí/náprava › 17.50 Přední náprava › 17.50.41 Příčné rameno/rameno/stabilizátor — Řada 690 (modely 6**) · Řada 901 · Řada 902 · Řada 903 · Řada 904

Platí také pro motory/převodovky: 730 408, 730 409, 730 410, 730 411, 730 413, 730 414, 732 2**

AR33.20-D-1452-03A

Attach transverse control arm to steering knuckle and front axle beam

Wheel location, hub

Number

Designation

Front axles
730.408/409/410/
411/413/414/
415/606

Front axle
732.2 in model 690.6

BA33.20-N-1003-01A

Bolt, stop plate to transverse control arm

M10

Nm

60

60

BA33.20-N-1005-01A

Nut, wishbone to steering knuckle

M201.5

Nm

280

280

Attach transverse control arm to steering knuckle and front axle beam

D33.20-0002-01

1 Coat rubber springs of wishbone (12) with oil.

2 Support wishbone (12) with jack.

3 Insert front wishbone arm into bearing bracket and fix with wishbone bolt (2).

Replace nut on wishbone screw joint, but do not tighten.

4 Lower jack under wishbone.

Attach transverse control arm to steering knuckle and front axle beam

D33.20-0004-01

5 Insert the rear wishbone arm into the bearing bracket and fix with wishbone bolt (2).

Replace nut on wishbone screw joint, but do not tighten.

Attach transverse control arm to steering knuckle and front axle beam
Attach transverse control arm to steering knuckle and front axle beam

D33.20-0021-01

D33.20-0020-01

6 Bolt stop plate (7) onto wishbone (12) .

7 Position the steering knuckle (10) on the wishbone joint, fit the heat shield (only axle 730.411/414) and screw the retaining nut (13) on to the wishbone joint .

Replace nut (13).