Remove/install stabilizer bar on front axle

AR32.20-P-0300IW

Remove/install stabilizer bar on front axle

13.4.11

 

Remove/install

 Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A



Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

1

Raise vehicle

2

Detach lower engine compartment paneling

AR61.20-P-1105M

3

Detach link rod (23) from torsion bar (10)

 Check rubber mount of link rod (23) for damage and replace link rod (23) if necessary.

 Installation: Tighten nut (23b) only after vehicle is in ready-to-drive condition, if necessary, turn in the steering.

 Nut, link rod to torsion bar (10)

*BA32.20-P-1002-02H

4

Dismantle torsion bar (10) at left and right on retaining brackets (21b) from front axle carrier and remove torsion bar (10)

 Check rubber mount of torsion bar (10) for damage and wear and replace torsion bar (10) if necessary.

 The rubber mounts are molded onto the torsion bar (10).

 Bolts (21e) torsion bar to front axle carrier

*BA32.20-P-1003-02H

5.1

Dismantle retaining bracket (21b) from torsion bar (10)

If necessary

 Bolts (21g) bottom retaining brackets to top retaining brackets

*BA32.20-P-1005-02H

6

Detach link rod (23) from steering knuckle (5)

 Check boot of link rod (23) for damage and replace link rod (23) if necessary.

 Installation: Counterhold joint of link rod (23) when tightening so that the boot is not twisted or damaged.

 Nut, link rod to steering knuckle

*BA32.20-P-1004-02H

7

Install in the reverse order

Number

Designation

Model 220.083/
084/087/
183/184/
187

BA32.20-P-1002-02H

Nut, link rod to stabilizer bar

Nm

95

BA32.20-P-1003-02H

Bolt, torsion bar to front end

Nm

40

BA32.20-P-1004-02H

Nut, link rod to steering knuckle

Nm

95

BA32.20-P-1005-02H

Bolt, bottom retaining bracket to top retaining bracket

Nm

95