AR27.60-P-0990I | Remove/install and set shift rod | 25.2.98 |
TRANSMISSION 722.6 in MODEL 215, 220, 240
TRANSMISSION 722.9 in MODEL 215, 220
P27.60-2013-06
1 Retainers
2 Security bolt
33 Range selector lever
63 Shift rod
97 Intermediate lever
98 Rod head
99 Grub screw
N15/5 Electronic selector lever control module
| Remove | ||
Danger! | Risk of death. Death may result if vehicle slips or topples from the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | |
| The vehicle must be horizontal | Position vehicle on the lifting platform. | |
1 | Move selector lever to position "D". | ||
2 | Raise vehicle. | ||
3.1 | Remove shield in the area of the electronic selector lever module control unit (N15/5) | Models 215, 220 | |
3.2 | Remove cover from shield | Model 240 | |
4 | Unclip locking plates (1) using a screwdriver | ||
5 | Detach rod head (98) from intermediate lever (97) | ||
6 | Position range selector lever (33) in position "R" | ||
7 | Detach shift rod (63) at range selector lever (33) | ||
8 | Remove shift rod (63) together with rod head (98) | ||
| Inspect | ||
9 | Check bushes in range selector lever (33) and in intermediate lever (97) for damage and replace if necessary | ||
| Setting, installing | ||
10.1 | Saw slot in bolt head of locking bolt (2) and unscrew locking bolt (2) from rod head (98) | Vehicles with locking bolt | |
10.2 | Loosen grub screw (99) | Vehicles with grub screw | |
11 | Attach shift rod (63) at range selector lever (33) | ||
12 | Move range selector lever (33) to position "D" | ||
13 | Attach rod head (98) to intermediate lever (97) | ||
14 | Clip in locking plates (1) | Install new locking plates (1) | |
15.1 | Screw in locking bolt (2) at rod head (98) | Vehicles with locking bolt | |
Replace locking bolt (2). For tightening, counter-press at rod head (98) Do not move range selector lever (33) from position "D". | |||
| |||
15.2 | Tighten grub screw (99) | Vehicles with grub screw | |
Replace grub screw (99). For tightening, counter-press at rod head (98) Do not move range selector lever (33) from position "D". | |||
| |||
16 | Perform function check | ||
17.1 | Install shield in the area of the electronic selector lever module control unit (N15/5) | Models 215, 220 | |
17.2 | Install cover in the shield | Model 240 |
Tightening torques for shift rod
Odkazované dokumenty
- as0000z001001a Nebezpečí ohrožení života v případě sesunutí nebo překlopení vozu z dílenského zvedáku