AR27.19-T-0800AC | Remove/install inductive sensor (output rpm) | 22.2.07 |
TRANSMISSION 721.108 /109 /141 /151 /181 /182
T27.19-0033-11
1 Hexagon nut
2 Washer
3 Cover
4 O-ring
5 Inductive sensor (output rpm)
6 Inductive sensor retaining bolt
7 Electrical connectors
| Remove/install | ||
1 | Unscrew hexagon nuts (1) and remove cover (3) | Installation: Replace O-ring (4) and hexagon nuts (1). | |
| |||
2 | Disconnect electrical connector (7) from inductive sensor (5) | Pull on the flat-pin connectors, not on the cable, using suitable pliers. | |
3 | Unscrew inductive sensor retaining bolt (6) and remove induction-type pulse generator (5) | | |
Installation: When replacing inductive sensor, determine thickness of shims: | |||
Adjusting inductive sensor (output rpm) | |||
Measuring rod, ZF-Friedrichshafen AG, D-88046 Friedrichshafen, Germany | |||
Test device, ZF-Friedrichshafen AG, D-88046 Friedrichshafen, Germany | |||
Adjusting disk, ZF-Friedrichshafen AG, D-88046 Friedrichshafen, Germany | |||
4 | Install in the reverse order |
Test and adjustment values for automatic transmission
Number | Designation | Trans-mission 721.141 | Trans-mission 721.108 | Trans-mission 721.109 | Trans-mission 721.151/ | |
BE27.19-N-1002-01B | Adjustment dimension for inductive sensor (output rpm) | mm | 0.6...0.7 | 0.5...0.7 | 0.5...0.7 | 0.6...0.7 |
Electrical system, transmission
Number | Designation | Trans-mission 721.141 | Trans-mission 721.108 | Trans-mission 721.109 | Trans-mission | |
BA27.19-N-1013-02D | Bolt, inductive sensor (output rpm) to transmission output shaft housing cover | Nm | - | 10 | 10 | - |
Cover