Remove/install sensor plate

Designation

Model
690.6, 901, 902, 903, 904, 905 except Minibus Sprinter Low Floor

BA41.10-N-1004-01B

Bolt, retaining bracket to frame floor

AR26.60-D-0017B

Remove/install sensor plate

12.4.10

TRANSMISSION 716.643 in MODEL 901.6##, 902.6##, 903.6##, 904.6## ## as of 159193

TRANSMISSION 716.622 in MODEL 208.344 /444 with CODE (424) Sequentronic automated manual transmission (SEQ)

TRANSMISSION 716.662 in MODEL 208.348 /448 with CODE (424) Sequentronic automated manual transmission (SEQ)

TRANSMISSION 716.6 in MODEL 203, 209.361 /342 with CODE (424) Sequentronic automated manual transmission (SEQ)

D41.10-1101-01

Van only

1 Propeller shaft retaining bracket

2 Screw

D26.19-1111-01

3 Sensor plate connector

4 Screw

5 Sensor plate

Modification notes

16.5.06

"Disconnect/connect battery ground line" removed

 	Remove/install
1.1	Remove transmission	Model 208.344/348/444/448, 203, 209.361	AR26.10-P-0020E
2.1	Shift gear into "N" position	Model 901, 902, 903, 904
4.1	Remove propeller shaft retaining bracket (1)	Model 901, 902, 903, 904
			*BA41.10-N-1004-01B
5.1	Remove engine crossmember at rear	Model 901, 902, 903, 904	AR22.10-D-1170B
6	Detach connector (3) from sensor plate (5)
7	Unbolt sensor plate (5)		*BA26.19-N-1004-01B
		 Installation: Coat sealing surfaces of transmission housing sealing compound, the sealing surfaces must be free from oil and grease.	*BR00.45-Z-1015-01A
8	Install in the reverse order
9	Teach in turning angle sensors	WITH DAS

 Sensors

Number	Designation		Trans-mission 716.622/ 662	Trans-mission 716.643	Trans-mission 716.623


BA26.19-N-1004-01B	Bolt, sensor plate to transmission housing	Nm	3	3	3

 Propeller shaft

Repair materials

Number	Designation	Order number
BR00.45-Z-1015-01A	Loctite 5203 sealant	A 002 989 71 20 10