1 | Screw |
2 | Pressure plate |
3 | O-ring |
4 | Output flange |
W26.40-1069-06
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on self-locking nuts and bolts | ||
| Remove | ||
1 | Detach the propeller shaft from output flange (4) and place to one side | See information from body manufacturer. | |
2 | Unscrew bolt (1) and remove pressure plate (2) with O-ring (3) | Retainer wrench | |
3 | Pull output flange (4) off output shaft | Puller | |
| Check | ||
4 | Check radial shaft sealing ring for wear and condition | If the radial shaft sealing ring is worn or damaged. | |
| |||
Replace radial shaft sealing ring. | |||
| Install | ||
5 | Heat up output flange (4) to approx. 80 °C and mount | ||
6 | Tighten screw (1) with pressure disk (2) and new O-ring (3) | Bolt, output flange | |
Retainer wrench | |||
7 | Install propeller shaft to output flange (4) | See information from body manufacturer. |
000 589 89 33 00
Puller
717 589 00 31 00
Retainer wrench
Odkazované dokumenty
- ah0000n000101a Upozornění k samopojistným šroubům a maticím
- ar2640g3841ohc
- as0000z000201a Nebezpečí poranění kůže nebo očí při zacházení s horkými nebo žhavými předměty