Shown on transmission 715.570 |
1 | Gear cylinder |
2 | Electrical connector |
3 | Gear module |
4 | Cap |
5 | Electrical connector |
6 | Compressed-air line |
7 | Vent line |
8 | Shift shaft |
9 | Retaining ring |
S9 | Neutral position switch |
Y68 | Power-assisted gear shifting solenoid valve 1 |
Y69 | Power-assisted gear shifting solenoid valve 2 |
W26.60-1286-06
| Notes on compressed air connection systems | ||
| Remove/install | ||
1 | Remove shields at right from cab | Only with transmission 715.520. | |
2 | Remove gear cylinder (1) | ||
Do not remove hydraulic lines from gear cylinder (1). | |||
3 | Disconnect electrical connections (2, 5) | ||
4 | Remove neutral position switch (S9) | Neutral position switch to transmission housing | |
5 | Remove cap (4) | Installation: Replace cap (4). | |
6 | Shift transmission to neutral | If gear control defective | |
| |||
Shift transmission using adapter from vehicle tool kit into neutral. | |||
7 | Detach circlip (9) from shift shaft (8) | ||
8 | Remove air line (6) from gear module (3) | ||
9 | Detach bleed line (7) from housing of power-assisted gear shifting solenoid valve 1 (Y68) and power-assisted gear shifting solenoid valve 2 (Y69) | Only with transmission 715.570. | |
10 | Remove bolts from gear module (3) | Gear module at transmission | |
11 | Pull gear module (3) out of transmission | ||
12 | Rotate gear module (3) through 180° upwards and remove | Installation: Clean sealing surfaces and coat with sealant. | |
Loctite 5203 sealant | |||
13 | Install in the reverse order |
Odkazované dokumenty
- ah0018n000101a Pokyny k systémům konektorových spojů tlakového vzduchu
- ar2660w7000r
- ar6080w0003s