P25.20-2051-06
1 Clutch actuator
2 Electrical connector
3 Bolts
4 Screw
M18 Coupling motor
Modification notes
19.3.09 | Document revised as per new repair method. The clutch motor can be replaced individually in the event of damage. |
| Removing | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | |
1 | Raise vehicle with vehicle lift | ||
2 | Disconnect electrical connector (2) on clutch motor (M18) | ||
3 | Remove bolts (3) and remove clutch actuator (1) from transmission | ||
4 | Remove bolts (4) and remove clutch motor (M18) from clutch actuator (1). | Only remove clutch motor (M18) in the event of damage. | |
| Install | ||
5 | Position clutch motor (M18) in clutch actuator (1) as per picture (arrow B) screw on with bolts (4) | Only install clutch motor (M18) in the event of damage. | |
| |||
6 | Position clutch actuator (1) on transmission and fix in place with bolts (3) | Do not tighten down the bolts (3). | |
7 | Slide clutch actuator (1) towards the bell housing until the plunger of clutch actuator (1) abuts the release lever of the clutch operator | ||
8 | Starting from this position, slide the clutch actuator (1) by a further three graduation lines (arrow A) towards the bell housing and tighten bolts (3) | | |
9 | Contact electrical connector (2) on clutch motor (M18) | ||
10 | Lower vehicle with vehicle lift | ||
11 | Perform commissioning without control unit replacement | Observe menu guidance in DAS (DAS). | |
| Connect STAR DIAGNOSIS and read out fault memory |
Clutch operating mechanism
Odkazované dokumenty
- ad0000p200004mcc
- as0000z001001a Nebezpečí ohrožení života v případě sesunutí nebo překlopení vozu z dílenského zvedáku