Produtos para reparos
Número | Denominação | Número de pedido |
BR00.45-B-1007-06A | Grease DBL 6812.00 | Klueber Lubrification |
BR00.45-B-1011-06A | Brake fluid as per DBL 7760.30 (DOT 4) | - |
B25.20-0007-10
The cylinder components must be washed only with hydrous alcohol (available in the drugstore).
Petroleum by-products such as gasoline, kerosene or diesel oil damage the rubber parts.
1 Remove the z folded protection (11) and remove the rod from it (10).
2 Remove elastic ring (9), remove the complete piston (6) and the spring (5).
3 Remover the plug (4) and the bleeder (3).
4 Wash the cylinder inner part with hydrous alcohol. If there are oxidation signs, use a fine steel sponge. If the oxidation still remains, replace the complete cylinder.
5 With the cylinder (1) in good conditions, perfectly clean and lubricated with the specified brake fluid, install in the following order, the new repair components:
Spring (5), pay attention to its correct assembly position.
Complete piston (6) with the gasket (8) and the sealing ring lubricated with the specified brake fluid (7).
Inner elastic ring (9).
Install the bleeder (3) and the new plug (4).
6 Check the free movement of the piston in the cylinder using the rod (10).
7 Install the new z folded protector (11) in the rod (10).
8 Lubricate the rod's contact end (10) with the piston (6) with long lasting grease.
9 Fit the protector (11) in the cylinder flange edge (1).
10 If the identification clamp (2) has been removed, it must be installed again. (the clamp indicates the number of the cylinder, its travel and diameter).
11 If the cylinder remains in storage or is not going to be used immediately, cover the outlet destined to the tubes with an appropriate plastic plug.