W25.10-1103-09
1 | Clutch pressure plate | 4 | Sleeve in clutch release bearing | 7 | Clutch plate | ||
2 | Bolts | 5 | Guide bearing | 9 | Assembly device | ||
3 | Centering drift | 6 | Flywheel |
| Remove | ||
1 | Remove engine or transmission | Select procedure according to design and accessibility. | |
2 | Insert centering drift (3) into guide bearing (5) in flywheel (6) | Centering drift | |
3 | Loosen screw/bolts (2) | Loosen bolts (2) in small increments in a crosswise pattern. This prevents any one-sided strain on the clutch pressure plate (1). | |
4 | Mount assembly device (9) to the clutch pressure plate (1) | ||
| 000 588 00 61 00 Assembly device | ||
5 | Remove bolts (2) uniformly | ||
6 | Lift up clutch pressure plate (1) with assembly device (9) | ||
7 | Remove clutch plate (7) | ||
8 | Remove assembly device (9) | Only if clutch pressure plate (1) is to be replaced. | |
9 | Check clutch parts for wear and damage | ||
| Clean | ||
10 | Clean profile grooves in clutch plate (7). | Only when clutch plate (7) is not to be replaced. | |
| |||
11 | Clean sleeve in clutch release bearing (4) | Only if clutch pressure plate (1) is not to be replaced. | |
12 | Clean guide bearing (5) in flywheel (6), guide tube on transmission and the hub profile on the transmission input shaft | | |
| Install | ||
13 | Insert centering drift (3) into guide bearing (5) in flywheel (6) | Centering drift | |
14 | Center clutch plate (7) on flywheel (6) over the centering drift (3) | ||
15 | Mount assembly device (9) onto clutch pressure plate (1) | Only if clutch pressure plate (1) is to be replaced. | |
| 000 588 00 61 00 Assembly device | ||
Before installation of the new clutch pressure plate (1) check whether the diaphragm spring reeds are correctly seated into the clutch bearing. | |||
16 | Install clutch pressure plate (1) using assembly device (9) above centering drift (3) | ||
17 | Tighten the bolts (2) in small stages in a crosswise pattern | While tightening ensure that the centering drift (3) can still be moved easily. | |
Clutch pressure plate to flywheel | |||
18 | Remove assembly device (9) | ||
19 | Remove centering drift (3) | Centering drift | |
20 | Install engine or transmission | ||
21 | Connect diagnostic system, start Xentry and perform quick test | ||
22 | Teach in clutch travel in drive control (FR) control unit | Only when clutch pressure plate (1) or clutch plate (7) is to be replaced. | |
23 | End XENTRY and disconnect diagnostic system |
950 589 00 61 00
Centering drift