1 | V-belt |
2 | Nut |
3 | Nut |
4 | Springs |
5 | Shock absorber |
6 | Screw |
7 | Screw |
8 | Clamping lever |
A | Adjustment dimension |
G13.21-3114-76
Warning | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves. | |
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
Topical note | Notes on self-locking nuts and bolts | ||
| Remove | ||
1 | Open hood. | See information from body manufacturer. | |
2 | Remove screw (6) from shock absorber (5). | ||
3 | Loosen nut (2) on clamping device. | This relaxes the springs (4). | |
4 | Unhook springs (4) from tensioning lever (8). | ||
5 | Move over clamping lever (8) and remove V-belt (1). | ||
6 | Check V-belt (1) for cracks and wear. | If problems exist, | |
| |||
Replace V-belt (1). | |||
| Install | ||
7 | Place V-belt (1) on belt pulleys. | ||
8 | Hook springs (4) into tensioning lever (8). | ||
9 | Screw on nut (2) until the shock absorber (5) is attached and the screw (6) can be screwed in. | ||
10 | Attach shock absorber (5) to tensioning lever (8) and tighten screw (6) slightly by hand. | ||
11 | Screw on nut (2) until the adjustment dimension (A) is set on the shock absorber (5). | The adjustment dimension (A) is the dimension from the center of screw (6) to the center of screw (7). | |
Adjustment dimension on shock absorber for clamping device | |||
12 | Tighten nut (3). | ||
13 | Tighten bolt (6). | ||
14 | Close hood. | See information from body manufacturer |
Odkazované dokumenty
- ah0000n000101a Upozornění k samopojistným šroubům a maticím
- as0000z000101a Nebezpečí poranění přivřením nebo přiskřípnutím při pracích na předepnutých pružinách nebo tělesech pružin
- as0000z000901a Nebezpečí poranění přivřením nebo přiskřípnutím, v extrémním případě amputací končetin při zásazích do mechaniky