ar0716g100701ma

Fill fuel low-pressure circuit on engine with hand pump

Typ ar · téma 07.16 · verze 0100 · 2018-07-03

Platí pro: Engine 933.9, 935.9 in model 800.220 with code MK28 (Fuel filter with water separator and fluid level sensor, heated)

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 1 Motor › 07 Příprava směsi › 07.16 Systém vstřikování paliva vznětového motoru Common-Rail — Řada 800 (modely 220) · Řada 933 (modely 9**)

EinPAS 16 Zásobování motoru palivem/energií › 16.10 Zásobování palivem › 16.10.1 Základní informace — Řada 800 (modely 220) · Řada 933 (modely 9**)

Platí také pro motory/převodovky: 935 9**

AR07.16-G-1007-01MA

Fill fuel low-pressure circuit on engine with hand pump

Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

Engine

933.9, 935.9 in model 800.220

with code MK28 (Fuel filter with water separator and fluid level sensor, heated)

Fill fuel low-pressure circuit on engine with hand pump

1

Remove handle (1) from hand pump on fuel filter module (2).



2

Actuate hand pump on handle (1) with approx. 100 pump strokes within approx. 1 min until noticeable pressure is present at hand pump.



3

Start engine within about 5 s at the engine start and engine stop button, allow to run in idle, then subsequently allow engine to run at higher engine speeds.


If engine fails to start or only runs for a brief period,


Repeat operation step 2.


4

Switch off engine.



5

Screw handle (2) finger-tight into hand pump.


G47.20-3189-03

Odkazované dokumenty