AR03.30-G-1600NA | Remove/install belt pulley/vibration damper | 25.1.11 |
ENGINES 902.912 in MODEL 405.210 /230
for USA/Canada only
ENGINES 906.936 in MODEL 405.210 /230
for USA/Canada only
ENGINES 906.967 in MODEL 405.210 /230 with CODE (M03) Increased engine output,
for USA/Canada only
G03.30-3109-11
Shown on engine 906
1 Poly-V-belt
2 Poly-V-belt
3 Tensioning device
4 Vibration damper
5 Belt pulley
6 Internally serrated bolt
| Remove/install | ||
1 | Remove propeller shaft for PTO transmission from belt pulley/vibration damper | With PTO transmission (Code N08) | |
2 | Remove poly V-belts (1, 2) | ||
3 | Remove tensioning device (3) | ||
4 | Attach cranking/blocking device | ||
| |||
| |||
5 | Remove vibration damper (4) together with belt pulley (5) | | |
| |||
6 | Remove belt pulley (5) from vibration damper (4) | Only if vibration damper (4) or belt pulley (5) is being replaced. | |
| |||
7 | Measure length of shank of multipoint socket bolts (6) | If the max. shank length was exceeded: | |
Replace multipoint socket bolt (6). | |||
8 | Install in the reverse order |
Belt pulley/vibration damper
Number | Designation | Engine | ||
BE03.30-N-1001-02E | Bolt, vibration damper to crankshaft | Thread diameter | M | 141.5 |
Length of shank when new | mm | 60.0 | ||
Max. shank length | mm | 61.0 | ||
Timing case
Number | Designation | Engine | |
BA01.60-N-1002-01J | Inspection hole closure cover to timing case | Nm | 25 |
Flywheel, driven plate, vibration damper, starter ring gear
Number | Designation | Engine | |||
BA03.30-N-1002-01O | Bolt, vibration damper to crankshaft | M16 | Stage 1 | Nm | 50 |
Stage 2 | Nm | 210 | |||
Stage 3 | ° | 90 | |||
M14 | Stage 1 | Nm | 50 | ||
Stage 2 | Nm | 125 | |||
Stage 3 | ° | 90 | |||
BA03.30-N-1004-01O | Bolt, belt pulley to vibration damper | Nm | 60 | ||
PTO transmission
Number | Designation | Model | |
BA26.45-N-1001-03A | Bolt connecting propeller shaft to | Nm | 65 |
904 589 04 63 00
Cranking device
Screwdriver bit
904 589 01 10 00