ap4260d4381a

Compressed air drier - replacing granulate cartridges

Typ ap · téma 42.60 · verze 0200 · 2010-07-27

Platí pro: MODEL 668, 670 with ENGINE 602.9, 904.9, 900.9 with CODE (B65) Heated compressed air drier (single-chamber system) with CODE (B66) Compressed air drier (single-chamber system) MODEL 905 with ENGINE 612.9 Except Sprinter minibus

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 2 Podvozek › 42 Brzdy - hydraulická část a mechanická část › 42.60 Vzduchotlaková část — Řada 602 (modely 9**) · Řada 668 · Řada 670 · Řada 900 (modely 9**) · Řada 904 (modely 9**) · Řada 905

EinPAS 21 Brzdy/podtlakový systém/vzduchotlaké zařízení › 21.35 Vzduchotlaké zařízení › 21.35.30 Vysoušení/regulace/čistění — Řada 602 (modely 9**) · Řada 668 · Řada 670 · Řada 900 (modely 9**) · Řada 904 (modely 9**) · Řada 905

Platí také pro motory/převodovky: 612 9**

AP42.60-D-4381A

Compressed air drier - replacing granulate cartridges

20.7.10

MODEL 668, 670 with ENGINE 602.9, 904.9, 900.9
with CODE (B65) Heated compressed air drier (single-chamber system)
with CODE (B66) Compressed air drier (single-chamber system)

MODEL 905 with ENGINE 612.9
Except Sprinter minibus

Compressed air drier - replacing granulate cartridges

N42.60-0211-01

Shown on model 668, 670, 905

Compressed air drier with electrical air compressor system

1 Granulate cartridge

Compressed air drier - replacing granulate cartridges

N42.60-0212-01

Shown on model 668, 670

Compressed air drier without electrical air compressor system

1 Granulate cartridge

2 Sealing ring

Modification notes

23.6.10

Document revised completely.

Removing

1.1

Fill compressed-air system until pressure governor cuts off

The compressed air drier is bled through filling the compressed-air system.

1.2

Bleed compressed air drier by releasing compressed air.

Vehicles with electrical compressed-air system.

Loosen the line at connection "1" of the compressed air drier and release compressed air.

Installation: Tighten the line at connection "1" of the compressed air drier after releasing the compressed air.

2

Unscrew granulate cartridge (1).

Removed granulate cartridge (1) falls into the category of special waste due to the oil residues it contains, and must be treated the same as oil filters.

*655589006100

3

Take off seal (2)

Only for vehicles without electrical compressed-air system.

Install

4

Apply thin coating of grease to new sealing ring (2) and then pull on sealing ring

Only for vehicles without electrical compressed-air system.

*BR00.45-Z-1014-06A

5

Slightly grease thread and seal (arrow) of the new granulate cartridge (1)

*BR00.45-Z-1014-06A

6.1

Screw up granulate cartridge (1) by hand and tighten to the specified torque

Model 668, 670 without electrical compressed-air system

*BA42.60-N-1001-01E

6.2

Screw on the granulate cartridge (1) by hand until the sealing ring (arrow) lies flush against the housing, then tighten by rotating by another half a revolution

Compressed air drier with electrical air compressor system.

Checking

7

Check compressed air drier for leaks

Vent compressed air drier, to do so switch on pressure regulator.

8

Confirm replacement of granulate cartridge (1) in maintenance booklet.

Air drier

Number

Designation

Model
668, 670

BA42.60-N-1001-01E

Granulate cartridge to air drier

Nm

15

Compressed air drier - replacing granulate cartridges

655 589 00 61 00

Cartridge wrench

Repair materials

Number

Designation

Order number

BR00.45-Z-1014-06A

ATE grease

-