Platí pro: Engine 902.9 Engine 904.925/973/977/978/981 ## up to 415751 Engine 906.918 ## as of 415752 Engine 906.918/974/975/977/983 ## as of 415752, 906.988/994/998 Engine 906.933 ## as of 415752 Engine 924.913/994/995/996 Engine 926.000/910/926/996/999 Engine 926.911/920 Engine 926.988 in model 382.180/181
Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.
Platí také pro motory/převodovky: 924 913, 924 994, 924 995, 924 996, 926 000, 926 910, 926 911, 926 920, 926 926, 926 988, 926 996, 926 999
AP05.30-B-0560-01B
Check and adjust valve clearance
Engine 904.9, 906.9, 924.9, 926.9
Engine
902.9
Engine
904.925/973/977/978/981 ## up to 415751
Engine
906.918 ## as of 415752
Engine
906.918/974/975/977/983 ## as of 415752, 906.988/994/998
Engine
906.933 ## as of 415752
Engine
924.913/994/995/996
Engine
926.000/910/926/996/999
Engine
926.911/920
Engine
926.988 in model 382.180/181
Test value for the valves
Number
Designation
Engine 902.9, Engine 906.9 from 415752
Engines 924.9, 926.9
BE05.30-B-1011-01D
Valve lash (adjustment values)
intake
mm
0,40
0,40
exhaust
mm
0,60
0,60
Test value for the valves
Number
Designation
Engine 902.9, Engine 906.9 from 415752
Engines 924.9, 926.9
BE05.30-B-1012-01D
Tolerance for the valve clearance check
intake
mm
-0,05...+0,05
-0,05...+0,05
exhaust
mm
-0,10...+0,10
-0,10...+0,10
Engine Command - General
Number
Designation
Engines 902.9, 904.9, 906.9
Engines 924.9, 926.9
BA05.00-B-1001-01A
Jam nut of rocker arm adjustment
Nm
25
25
B05.30-0014-01
Intake valve
Exhaust valve
B05.30-0013-01
1
Check the clearance of the valves (arrows), with the feeler gauge between the rocker arm and the valve bridge (intake valves) or between the rocker arm and the valve rod (exhaust valve)
The valve clearance (arrow) must be set when out of tolerance
2
Adjust the valve clearance (arrow)
With a suitable wrench, loose the counternut (2) and adjust the valve clearance, working on adjustment screw (1). Tighten the counternut (2) to fasten the adjustment screw (1).
3
Check the valve clearance (arrow) and adjust it again if necessary
Valve clearance is correct when, after tightening the counternut (2), a slight resistance is noticed when moving the feeler gauge between the rocker arm and the valve bridge . (intake valves) or between the rocker arm and the valve rod (exhaust valve).
When making the adjustment of valve clearance, use feeler gauges corresponding to the "setting values". They are not valid for setting works.
