Commercially available tools
Number | Designation | |
WH58.30-Z-1006-14A | Flat drawing die for auxiliary heater, |
S83.70-1021-01
1 Take the drill hole pattern out of the parts set and move the position of the same 26 mm (see illustration)
The drill hole pattern must be placed on the bottom plate, centred with respect to the edge.
2 Drill two 26 mm holes for the heater
S83.70-1022-01
3 Cut the floor lining in accordance with the drill hole pattern.
4 Flatten the support surface of the floor plate.
For this operation the tool from the firm Eberspächer can be used.
5 Drill the fastening holes (4 7.5 mm holes) in the floor plate and 1 7.5 mm hole for fuel connection according to the tool.
6 Remove the tool and cover the holes with anti-rust paint.
S83.70-1023-01
7 Install the 75 suction grid in the heater and the 75 air outlet.
8 Proceeding from below, insert the heater and its gasket as well as M6 nuts (4 units) and tighten them.
S83.70-1024-01
9 With the 20/32 clamp, secure the combustion air suction tube (25 mm inn. ) in the heat together with the muffler.
10 Place the suction tube on the inside of the side wall, slightly inclining forwards, and secure it with 50 mm clamp and 4.8 x 16 plate thread screw.
S83.70-1025-01
11 With the aid of the 26/28 mm clamp, install the exhaust hose (24 mm inn. / 660 mm long) in the heater together with the terminal sleeve.
12 Route the exhaust hose backwards and screw it with the aid of 2 28 mm clamps and the relative plate thread screws.
When drilling in the protection plate area pay attention to the fuel outlet!