Retrofit auxiliary headlamp

AN82.10-G-2020NA

Retrofit auxiliary headlamp

14.2.12



Install

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

1

Disconnect battery

 First of all disconnect negative terminal then the positive terminal.

2

Remove plug (1)

3

Unscrew screws (2) and remove plate (3)

4

Remove cover (4) from A-pillar

5

Retrofit auxiliary headlamp wiring harness (6)

AN82.10-G-2020-02NA

6

Screw mount (7) to A-pillar with screws (2) and (18)



*BA82.10-N-1001-04A

7

Screw bracket (12) to mount (7) with screw set (19)

8

Align auxiliary headlamp (13) and slightly tighten nut (16)

9

Connect battery

 First of all connect the positive terminal then the negative terminal.

10

Carry out operational check

11

Adjust auxiliary headlamp (13) according to national regulations

12

Tighten nut (16)

13

Position cap (17)

14

Install cover (4) at A-pillar

Number

Designation

MODEL 405 with CODE (L47)

BA82.10-N-1001-04A

Bracket for additional headlamp on A-pillar

Nm

20