Fault code description - ME-SFI - PWM-solenoid of torque converter lockup

Typ ad · téma 07.61 · verze 0105 · 2003-06-10

Platí pro: ENGINES 112.910, 112.911 up to 31.5.00, 112.920, 112.921 up to 31.5.00, 112.923, 112.940 /941 /942 up to 31.5.00, 112.943 ENGINES 113.940 /942 /943 up to 31.5.00, 113.961 ENGINES 112.945, 113.962 up to 30.11.00 in MODEL 463 ENGINE 120

Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.

Zařazení

Funkční skupina 1 Motor › 07 Příprava směsi › 07.61 Systém vstřikování paliva a zapalování zážehového motoru ME — Řada 463

EinPAS 15 Motor › 15.45 Management motoru › 15.45.1 Základní informace — Řada 463

Platí také pro motory/převodovky: 112 910, 112 911, 112 920, 112 921, 112 923, 112 940, 112 941, 112 942, 112 943, 112 945, 113 940, 113 942, 113 943, 113 961, 113 962, 120 ***

AD07.61-P-4000-35A

Fault code description - ME-SFI - PWM-solenoid of torque converter lockup

1	Fault code	
2	Fault storage Activation of malfunction indicator lamp for engine diagnosis (EURO3/4) or CHECK ENGINE (MIL) 	after the end of the test period and faults after two successive driving cycles with faults
3	Frequency of the test	continuous
4	Checked signal or status	Duty cycle for PWM-solenoid activation
5	Fault setting conditions Lower limit Upper limit Test duration	Duty cycle less than 5 % Duty cycle greater than 94 % approx. 1 s
6		Faults (line interruption and short circuit) are detected by the ETC control module and sent via the CAN data bus to the ME-SFI control module. The faults are stored and the malfunction indicator lamp is activated by the ME-SFI control module. Also read out ETC diagnostic trouble code memory, fault code 5.