ad0000p200003b
Connecting Hand-Held Tester (HHT), reading out fault memory
Typ ad · téma 00.00 · verze 0103 · 2006-07-25
Platí pro: MODEL 124 /, 129.060 /061 /066, 201 (except 124.034 /036)
Není k dispozici v jazyce „cs“; zobrazeno v jazyce Angličtina.
Zařazení
Funkční skupina 0 Celkový › 00 Celkové vozidlo › 00.00 Všeobecné — Řada 124 (modely 003, 004, 007, 008, 019, 020, 021, 022, 023, 026, 027, 028, 029, 030, 031, 032, 040, 041, 042, 043, 050, 051, 052, 060, 061, 062, 066, 079, 080, 081, 082, 083, 088, 090, 091, 092, 104, 105, 106, 107, 120, 125, 126, 127, 128, 129, 130, 131, 133, 180, 185, 186, 188, 190, 191, 193, 226, 230, 290, 330, 333, 393) · Řada 129 (modely 060, 061, 066) · Řada 201
EinPAS 25 Palubní síť/síť/multifunkční systém › 25.15 Síť/multifunkční systém › 25.15.1 Základní informace — Řada 124 (modely 003, 004, 007, 008, 019, 020, 021, 022, 023, 026, 027, 028, 029, 030, 031, 032, 040, 041, 042, 043, 050, 051, 052, 060, 061, 062, 066, 079, 080, 081, 082, 083, 088, 090, 091, 092, 104, 105, 106, 107, 120, 125, 126, 127, 128, 129, 130, 131, 133, 180, 185, 186, 188, 190, 191, 193, 226, 230, 290, 330, 333, 393) · Řada 129 (modely 060, 061, 066) · Řada 201
AD00.00-P-2000-03B
| Connecting Hand-Held Tester (HHT), reading out fault memory
| Models 124 except 124.034/036, 129.060/061/066, 201
|
|
Commercially available tools
Number
| Designation
|
|
WH58.30-Z-1036-13A
| Handheld tester (HHT)
| 651 100 01 99
|
WH58.30-Z-1037-13A
| Test cable (multiplexer)
| 651 100 40 99
|
1 Connect Hand-Held Tester (087) with test cable (Multiplexer) (094) to data link connector (X11/4).
2 Switch on ignition.
3 According to instructions on display:
a) Read out/erase fault memory
b) Read out actual values
c) Perform actuations
d) Program control modules
4 Disconnect HHT.
087 Hand-Held Tester (HHT)
094 Test cable (Multiplexer)
X11/4 Data link connector
Observe system-specific deviations which are listed for the appropriate diagnosis description in the chapter "Advanced information on diagnostics".
Stored faults which can be caused by disconnected cables or a simulation must be erased in the fault memory upon completion of the work.
