Adjust gap

AR43.40-W-1400A

Adjust gap

29.3.07

MODEL 930, 934, 950, 952, 953, 954, 958 with CODE (BD9) Telma retarder Focal F 3300

W43.40-0006-06

1 Propeller shaft

2 Rear rotor

3 Setting ring

4 Stator

5 Bolts

6 Adjusting panel

7 Front rotor

Modification notes

29.3.07

Nut, rear rotor to intermediate flange

	Removal
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Detach propeller shaft (1) from propeller shaft flange on the transmission		AR41.10-W-0050A
	Adjust
2	Switch off ignition
3	Undo bolts (5) of stator (4)
4	Remove adjusting segments (6)
5	Install new adjusting segments (6) of appropriate thickness
6	Tighten bolts (5) of stator (4)		*BA43.40-N-1004-01A
7	Measure gap width between stator (4) and front rotor (7), repeat adjustment procedure if necessary		AR43.40-W-1500A
8	Remove rear rotor (2)
9	Remove adjusting disk (3)
10	Install new adjusting disks (3) of appropriate thickness
11	Install rear rotor (2)		*BA43.40-N-1001-01A
12	Measure gap width between stator (4) and rear rotor (2), repeat adjustment procedure if necessary		AR43.40-W-1500A
	Install
13	Install propeller shaft (1)		AR41.10-W-0050A

 Retarder (electric)

Number	Designation		Model 930, 932, 933, 934 with Telma retarder F3300	Model 950, 952, 953, 954, 958 with Telma retarder F3300


BA43.40-N-1001-01A	Nut, rear rotor to intermediate flange	Nm	93	93
BA43.40-N-1004-01A	Bolt, stator to stator carrier	Nm	130	130