1 | Bracket |
2 | Forked cross member |
3 | Bearing bracket |
B27 | Front axle position sensor |
W31.00-1164-11
Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | ||
Topical note | Notes on self-locking nuts and bolts | ||
| Remove | ||
1 | Lower the vehicle onto the stop buffers with the level control operating unit | ||
2 | Switch off ignition | ||
3 | Disconnect electrical connector from travel sensor on front axle (B27) | ||
4 | Remove bracket (1) with mounted travel sensor on front axle (B27) from sickle-shaped cross member (2) | Secure bracket (1) with mounted travel sensor on front axle (B27) against falling down. | |
5 | Remove sickle-shaped cross member (2) | ||
| Check | ||
6 | Check vehicle frame in area of mounting of bearing brackets (3) at right and left for damage | Only conduct, if the removed sickle-shaped cross member (2) was damaged war and had to be replaced. | |
If damaged. | |||
| |||
Perform suitable repair to match extent of damage. | |||
7 | Check bearing bracket (3) at right and left for damage | Only conduct, if the removed sickle-shaped cross member (2) was damaged war and had to be replaced. | |
If damaged. | |||
| |||
Replace damaged bearing bracket (3). | |||
Frame sections to frame | |||
| Install | ||
8 | Install sickle-shaped cross member (2) | Crossmember (under transmission) to bearing bracket | |
9 | Mount bracket (1) with mounted travel sensor on front axle (B27) onto sickle-shaped cross member (2) | Holder for front axle travel sensor to crossmember | |
10 | Connect electrical connector to travel sensor on front axle (B27) | ||
11 | Raise vehicle using level control operating unit back to normal level |