AR26.60-D-6633A | Adjust shift cables for manual transmission | 16.6.10 |
TRANSMISSION 711.651 in MODEL 906.1 /2 /6 /7 with ENGINE 271.951, 646.984 /985 /986 /989 /990
TRANSMISSION 711.660 in MODEL 906.1 /2 /6 /7 with ENGINE 642.992, 646.984 /985 /986 /989 /990
TRANSMISSION 711.685 in MODEL 906 with ENGINE 642.896
D26.60-1187-10
1 Zero position catch
2 Security catch
3 Sliding piece
4 Sliding piece
| Removing | ||
1 | Shift transmission to neutral | ||
2 | Unclip shift lever sleeve and carefully slide upwards on the gearshift lever | Unclip shift lever sleeve in left upper corner first, to prevent damaging the rear locks and the shift lever frame. For this purpose, lift corner slightly and simultaneously press toward inside at side. Then remove the sleeve frame from the cover by moving back and forth. | |
Adjust | |||
3 | Lift lock tab (2) and push zero position catch (1) downward | The zero position catch (1) is located at correct position when gearshift lever can no longer be moved. | |
4 | Push sliding pieces (3, 4) on both shift cables downward using a screwdriver and allow them to spring back again | Use a long, thin screwdriver. | |
5 | Push zero position catch (1) upward until lock tab (2) engages | ||
6 | Check that shift mechanism is functioning correctly; repeat adjustment if necessary | The transmission must shift smoothly. | |
| Install | ||
7 | Clip in shift lever boot |